Intellinet Network Solutions 503723 manual Dns

Page 7

connectivity; if unlit, the connection isn’t ready. When lit, the amber LED indicates 100 Mbps connectivity.

NOTE: If your LAN is using a network segment other than 192.168.1.xxx, consider configuring one of the computers with an IP address of 192.168.1.xxx. The factory defaults of the switch are as follows:

Port base:

5900

 

IP address:

192.168.1.200

Subnet mask:

255.255.255.0

Default gateway:

192.168.1.254

DNS:

192.168.1.1

 

 

 

 

 

 

2.Go to the Web Management interface of the switch by entering https://<IP_address>:<PortBase+8> (e.g., https://192.168.1.200:5908) in the address bar of your browser; then log in (username = superuser; password = superu).

3.Go to the Main: LAN TCP/IP screen to re-configure the factory default settings listed above. If, as an example, you establish these settings:

Port base:

6080

IP:

192.168.1.36

Subnet mask:

255.255.255.0

Default gateway:

192.168.1.11

DNS:

192.168.1.1



Image 7
Contents Digital KVM over IP Switch quick install guide Page Introduction Front Panel compressed view Digital KVM over IP Switch SetupRear Panel compressed view Terminator Daisy-chain up to 16 levels Switch Configuration for LAN Connection Connected Computer SetupDNS Testing the Viewer Connection via the LAN/Internet Router/Firewall Configuration for Internet AccessPage Within a LAN Prima IPlocalIPportbase e.g Configuring Computer Names Switch Display OptimizationAdding, Editing or Deleting User Accounts Installing CertificatesChanging the Viewer Security Level Changing the Password PolicyUser Other Settings Restoring Factory Defaults