Juniper Networks 200 Series manual Power Fuse

Page 13

The Rear Panel

Power Fuse

Each NetScreen-200 Series device uses a 2.5 Amp, slow-blow power fuse rated for 250 Volts.

To replace a fuse on a NetScreen-200 Series device:

1.Take the device off-line by turning the power switch OFF and disconnecting the power cable.

2.Using a screwdriver, separate the lid of the external fuse cover from the surface of the power outlet.

3.Gently remove the fuse assembly.

4.Slide the new fuse into the opening until the fuse clicks into place.

5.Replace the power cable, then turn the device power switch ON.

NetScreen-200 Series

7

Image 13

Contents NETSCREEN-200 Series Copyright Notice Contents IX-I Guide Organization PrefaceJuniper Networks Netscreen Publications Command Line Interface CLI ConventionsOverview1 NetScreen-208 Device NetScreen-204 DeviceNETSCREEN-200 Systems Front Panel System Status LED DisplayAlarm Asset Recovery PinholeCompact Flash Card Slot Console and Modem PortsEthernet Interfaces Power SuppliesRear Panel Power Fuse Overview User’s Guide Installing the Device General Installation Guidelines Equipment Rack Installation GuidelinesPerforming EQUIPMENT-RACK Installation Front Mount Connecting the PowerMid-Mount Wiring a DC Power Supply Connecting the NETSCREEN-200 Device to Other Devices Installing the Device User’s Guide Configuring the Device Route Mode Transparent ModeOperational Modes Ethernet1 through ethernet8 NETSCREEN-200 Series Device InterfacesConnectivity Examples Connecting the Device AS a Single Security GatewayPerforming Device Connection Device Establishing AN HA Connection Between DevicesDevice Establishing a Terminal Emulator Connection Performing Initial Connection and ConfigurationSetting Port and Interface IP Addresses Changing Your Admin Name and PasswordSetting the IP Address of the Management Interface Configuring the Device for Telnet and Webui Sessions Starting a Console Session Using TelnetEstablishing a GUI Management Session Starting a Console Session Using DialupNetScreen WebUI application window appears Asset Recovery Using CLI Commands to Reset the DeviceUsing the Asset Recovery Pinhole to Reset the Device Configuring the Device User’s Guide Specifications Safety Certifications Electrical SpecificationNETSCREEN-200 Attributes EnvironmentalIndex IX-II