Software features
Cables and connectors
LEDs
Alarms, errors, and events
ATM2 OC48/STM16 IQ PIC with SFP
■Multiprotocol Label Switching (MPLS) circuit
■
■Support for idle cell or unassigned cell transmission
■OAM Fault Management processes Alarm Indication Signal (AIS), Remote Defect Indicator (RDI), and loop cells
■
■Local and remote loopback
■ATM Inverse ARP, which enables routers to automatically learn the IP address of the router on the far end of an ATM PVC
■Simple Network Management Protocol (SNMP):
■Management Information Base (MIB) 2 (RFC 1213)
■ATM MIB (RFC 1695)
■SONET MIB
■Unspecified bit rate (UBR),
■
■Support for F4 OAM cells
■Support for
■You can install different transceivers on the PIC. For information about installing and removing transceivers, see the PIC and Transceiver Installation Instructions.
■Duplex SC/PC connector (RX and TX)
■Optical interface
One tricolor per port:
■
■
■
■
■Alarm indication signal
■Bit error rate signal degrade
■Bit interleaved parity errors B1, B2, B3
■Errored seconds
■Loss of cell delineation (LOC), loss of frame (LOF), loss of pointer
■Payload mismatch
■Remote defect indication
■Severely errored framing (SEF), severely errored framing seconds
Table 17: Optical Interface Support for ATM2 OC48/STM16 IQ PICs
Optical Parameter | Intermediate Reach (IR) | Multimode |
Optical interface | Multimode |
ATM2 OC48/STM16 IQ PIC with SFP ■ 27