Hawking Technology HWU54DM manual Or G only This card can be compatible with both

	802.11 B or G only – This card can be compatible with both
	802.11g and 802.11b wireless stations. If there are only 802.11b
	wireless stations in the network, you can set the card to this mode.
	The same goes with 802.11g only wireless stations.
Tx BURST	Tx Burst enables the card to deliver the better throughput in the
	same period and environment.
B/G Protection	If you have a mix of 802.11b and 802.11g wireless stations in the
	network, it is recommended that you enable the protection
	mechanism. This mechanism can decrease the rate of data
	collisions between 802.11b and 802.11g wireless stations. When
	the protection mode is enabled, the throughput of the card will be
	a little lower due to more complex data packets that must be
	transmitted.
	Auto – Based on the status of the network and automatically
	disable/enable protection mode.
	O n – Always enable the protection mode.
	Off – Always disable the protection mode.
Fast Roaming	These settings should only be used for advanced system
	administrators only.
Tx Rate	There are several options including
	Auto/1/2/5.5/11/6/9/12/18/24/36/48/54Mbps for you to select.
	When the “Auto” is selected, the device will choose the most
	suitable transmission rate automatically. The higher data rate you
	designated in the network, the shorter distance is allowed
	between the card and the wireless stations.
	When the wireless mode is “802.11 B only”, the maximum data
	rate is 11Mbps (11b) so that there are only “Auto/1/2/5.5/11Mbps”
	options you can select.
Turn Off RF Button	If you want to turn off the radio of the card temporarily, click this
	button. To turn on the radio, click this button again.
CCX 2.0	Support Cisco Compatible Extensions function:
	1. LEAP turn on CCKM
	2. Enable Radio Measurement: can channel measurement every
	0~2000 milliseconds.
	3. Enable QOS: enable Quality of Service.
	NOTE: These settings should only be used for advanced system
	administrators only..
	23