Huawei v200r001 Typical Configuration of IP Fax, Table VC-2-9Monitoring and maintenance of IP Fax

User Manual - Configuration Guide (Volume 3)		Chapter 2
Versatile Routing Platform		IP Fax Configuration
	Table VC-2-9Monitoring and maintenance of IP Fax
	Operation	Command
	Open all of the debugging information switches of ipfax	debug ipfax all
	Open the debugging information switch of function api of ipfax	debug ipfax api
	Open the debugging information switch of main task of ipfax	debug ipfax cc
	Open the debugging information switch of controller of ipfax	debug ipfax controller
	Open the debugging information switch of level 1 error message of ipfax	debug ipfax error 1_level
	Open the debugging information switch of level 2 error message of ipfax	debug ipfax error 2_level
	Open the debugging information switch of level 3 error message of ipfax	debug ipfax error 3_level
	Open the debugging information switch of all levels of error messages of	debug ipfax error all
	ipfax
	Open the debugging information switch of T38 message of ipfax	debug ipfax t38
	Open the debugging information switch of cisco message of ipfax	debug ipfax cisco
	Open the debugging information switch for reading and writing fax data	debug vpm fax
	between vpm module and voice card.

2.4 Typical Configuration of IP Fax

The networking mode of IP Fax is basically the same as IP Phone. Thus, the functions of IP Fax can be realized only when the telephone sets in the network of IP Phone are replaced by facsimile machines. You can basically use the functions of IP Fax only if you can configure IP Phone. The operation is easy to use.

1)Networking Requirements

Suppose a company headquarter located in Shenzhen plans to send/receive faxes to/from its Beijing branch via IP network.

The fax number of its Beijing branch is 0101002, and the number of Shenzhen headquarter is 07551001.

The IP address used to access to the Internet port through the router in Beijing is

1.1.1.2.The IP address used to access to the Internet port through the router in Shenzhen is 1.1.1.1.

The facsimile machine in Beijing is connected with the second voice port on the router, and the facsimile machine in Shenzhen is connected with the first voice port on the router.

2)Networking Diagram

port2 1.1.1.2 1.1.1.1 port1

		Internet
0101002	Router	Router	07551001
	Beijing	Shenzhen
Figure VC-2-2Networking diagram for typical IP fax configuration

3)Configuration Procedure

The parameter settings for the router in Beijing is as follows:

Quidway(config)# dial-peer voice 1 voip

Quidway(config-peer-voip1)# destination 07551001

Quidway(config-peer-voip1)# session target ipv4:1.1.1.1

2-6