Transducer Switch

Thank You

Thank you for choosing Humminbird®, America's #1 name in fishfinders. Humminbird® has built its reputation by designing and manufacturing top-quality, thoroughly reliable marine equipment. Genuine Humminbird® accessories offer the opportunity to upgrade and expand the capabilities of your Humminbird® product.

Your Humminbird® accessory is designed for trouble-free use in even the harshest marine environment. In the unlikely event that your Humminbird® accessory does require repairs, we offer an exclusive Service Policy - free of charge during the first year after purchase, and available at a reasonable rate after the one-year period. For complete details, see the Warranty section included in this manual.

Contact our Customer Resource Center at 1-800-633-1468or visit our Web site at humminbird.com.

Installation Overview

Following are instructions for the installation of this accessory. Before you start installation, we encourage you to read these instructions carefully in order to get the full benefit from your Humminbird® accessory. If you find that any items are missing from your installation kit, call our Customer Resource Center at 1-800-633-1468or visit our Web site at humminbird.com.

The Transducer Switch comes with all the necessary hardware to allow you to connect your control head to two transducers. The transducers may be the same type of transducer with different mounting locations, or you can maximize your unit’s performance by using two different transducers. The switch is intended for installation on the console, and will work well on almost any boat.

Supplies: In addition to the hardware supplied with your Transducer Switch, you will need a hand drill with various size bits, a Phillips screwdriver, an adjustable wrench, and a 3 amp fuse.

Installation

Perform the procedures in the following sections to install the Transducer Switch on your boat. Before installing the Transducer Switch, gather all the parts you will need, and make sure that the planned location of the Transducer Switch will allow you to connect the two transducers to your control head.

1. Locating the Transducer Switch Mounting Position

There are two ways to find the mounting location, as follows:

Switch Panel: If your console already contains a switch panel with an available slot, slide the Transducer Switch into the designated slot until it snaps into place. Then skip ahead to procedure two.

In-Dash:If your console does not have a switch panel or a pre-made mounting location, you will need to create one yourself.

531870-1_A

Transducer Switch

Mounting the Switch

Boat Console

Switch