Humminbird 531871-1_A warranty Switching Between Units, Powering Off

Page 4

Unit Switch

4. Switching Between Units

Perform the following procedures to alternate between the control heads connected to your Unit Switch:

1.Make sure both control heads are powered on.

2.Press the Unit Switch to engage the desired control head.

5. Powering Off

It is important to make sure all accessories (switches, control heads, etc.) are powered off in order to avoid possibly draining the battery. To make sure your Unit Switch is disengaged, follow the steps below.

If your Unit Switch is connected to the fuse panel,

1. Power off your boat to disengage the switch.

If your Unit Switch is connected to a battery switch,

1. Turn the dial of the battery switch to the OFF position.

If your Unit Switch is connected directly to a battery,

1.Power off your boat.

2.Remove the Unit Switch wires from the battery.

4

531871-1_A

© 2011 Humminbird®, Eufaula AL, USA. All rights reserved.

Image 4
Contents Mounting the Switch Locating the Unit Switch Mounting PositionUnit Switch To connect the transducer to the Unit Switch To connect the control heads to the Unit SwitchInserting the Cable Connector To manually create a mounting locationConnecting the Power Cable To connect the connector clips to the Unit SwitchConnecting the Connector Clips To the Unit SwitchSwitching Between Units Powering OffIf your Unit Switch is connected to the fuse panel If your Unit Switch is connected to a battery switch