iP21 Display
PM Indicator
Sleep / NAP Indicator
Daylight Saving Time
Indicator
iPhone/iPod Indicator
Time Display | Battery Low Indicator | Alarm Indicator |
Install Clock Backup Battery
The iP21 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. The CR2032 battery comes installed in the unit. Simply pull the tab to initiate contact. If a power failure occurs or the AC adaptor is accidentally disconnected,the display backlight will not remain lit, but current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings. When the Battery Low indiator blinks on the display, the battery should be replaced.
1.Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery installation/replacement.
2.Using a Phillips screwdriver, open the battery compartment door located on the bottom of the unit.
3.Remove the old battery and insert one CR2032 button cell battery, checking
that the + side is facing upwards. Replace the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
Installing Backup Battery |
3