Gefen 4x2 HDMI user manual DIP Switch Guidelines, How to open the 4x2 Hdmi Switcher

Page 9

DIP SWITCH GUIDELINES

Inside the 4X2 HDMI Switcher is a bank of Dip Switches. Below is a table describing their functions. By default, all switches are set to the Off position.

Dip Switch #

Name

Description

1

Switching Delay

Adds a 3 second delay to switching

2

On Board EDID

Feeds a Generic HDMI EDID to all Inputs

3

IR Code Dip Switch

Corresponds to Dip Switch 1 on RMT16-IR

4

IR Code Dip Switch

Corresponds to Dip Switch 2 on RMT16-IR

5

Unused

 

6

Unused

 

7

Unused

 

8

Edge Select

+Edge Pixels

1

2

3

4

5

6

7

8

How to open the 4x2 HDMI Switcher:

To access the dip switches, first remove the 2 hex nuts on the back of the unit (2 for RS232 port). Remove the 5 Philips screws under the unit and the 4 screws on each side of the unit. Now carefully remove the cover of the 4x2 HDMI Switcher.

6

Image 9
Contents 4x2 Hdmi Switcher Technical Support Asking for AssistanceTechnical Support Hours Write ToTable of Contents Introduction Features FeaturesIncludes Panel Descriptions How to Connect the 4x2 Hdmi Switcher to your devices How to enable the Spdif on the 4x2 Hdmi SwitcherHow to Control the 4x2 Hdmi Switcher RMT4-IR Installation How to open the 4x2 Hdmi Switcher DIP Switch GuidelinesTerminal Settings RS-232 InterfaceBinary Table Specifications Warranty Page Ma-HDMI-442