TROUBLE SHOOTING THE SYSTEM
The following chart will help in solving most problems that may occur. Should any problem persist after you have made these checks, please consult your nearest Profile retailer. Before going through this check list, refer back to the wiring and operating procedures.
E 1~ E 10
ERROR CODES
The unit cannot be operated because of trouble. Press the "RESET" button 22 . If the indicator still appears after pressing the "RESET"
Button 22 , your unit needs repair. Please refer to the warranty section of this manual for details on getting the unit serviced.
SYMPTOM
No Power
Disc cannot be loaded or ejected.
No sound.
The function buttons do not work.
CAUSE New installation.
The vehicle's ignition switch is not on.
The fuse is blown.
There is a disc already in the player.
You are trying to put the compact disc in upside down. The compact disc is extremely dirty or defective.
The temperature in the car is too hot.
Condensation
The volume control is all the way down.
The speakers are bad.
The
SOLUTION
Press the RESET 22 button.
Turn the ignition switch to the accessory position. If there is still no power, check the fuses at the vehicle's fuse block or the radio's fuse leads.
Replace the fuse with another fuse of the same recommended value
Remove the disc in the player, then put in the new one.
Insert the compact disc with the label facing up.
Clean the compact disc with a compact disc cleaning solution or replace the defective compact disc.
Cool the inside of the vehicle, then try again.
Leave the disc player off and turn the vehicle's air conditioner on to remove the condensation
Test the speakers to determine if they need replacing.
Remove the disc, then
15