Gefen 4x4 DVI Matrix user manual RMT16-IR Installation

Page 8

RMT16-IR Installation

1.Remove battery cover from the back of the RMT16-IR remote.

2.Verify that dip switches 1 & 2 are in the down (OFF) position.

3.Insert the battery, hold the battery so that you can see the positive side fac- ing up. The side that is not marked must be facing down.

4.Test the RMT16-IR remote by pressing ONLY one button at a time. The indicator light on the remote will flash once each time you press a button.

WARNING: Do not press multiple buttons simultaneously and do NOT press buttons rapidly. These actions will cause the remote to reset and steps 1-4 will have to be repeated.

Note: The RMT16-IR ships with two batteries. One battery is required for operation, the second battery is complimentary.

5

Image 8
Contents 4x4 DVI Matrix Asking for Assistance Technical SupportTechnical Support Hours Write ToTable of Contents Or Operating the 4x4 DVI Matrix IntroductionOperation Notes Includes FeaturesFeatures Front Panel Panel LayoutUsing the 4X4 DVI Matrix RMT16-IR Installation IR Codes DIP Switch Guidelines Binary Table RS232 SettingsRS-232 Interface 4x4 DVI Matrix Rack Mount Diagram Specifications Troubleshooting Auto EqualizationTroubleshooting Diagram