Profile CA400M, CA640, CA600M, CA440 Power Connections, Connect the amplifier to the cars battery

Page 7

POWER CONNECTIONS

B+ REM GND

Fuse

RADIO'S REMOTE

TURN-ON OUTPUT

94.7

Bridged

Speaker

Output

LR

IN-LINE POWER FUSE

MOUNTED WITHIN 12"

FROM BATTERY RECOMMENDED

(NOT PROVIDED)

+-

CAR BATTERY

+12V

IMPORTANT! Before making any connections, disconnect the car’s battery until the installation is completed to avoid possible damage to the electrical system.

Connect the amplifier to the car's battery.

At times, the amplifier will need to draw large levels of current that cannot be provided by any circuit in the car's fuse box. We recommended using an 4 to 10 gauge power wire for your connections depending on the amplifier and length of the wire. Strip one end of the wire to connect to the terminal on the amplifier marked B+. Loosen screw terminal and connect bare wire and tighten. Use caution to make sure no stray wire stands come in contact with surrounding terminals causing short circuits. Run the wire directly to the positive terminal of the car's battery. Make sure to use an in-line fuse within 12” of the car's battery to protect the electrical system and amplifier against short circuits and/or power surges.

Connect the ground terminal of the amplifier to the car's chassis.

For the ground connection, use an 4-10 gauge wire (black) to connect to the terminal marked GND and then connect it to the car's chassis. Try to keep the length of the cable as short as possible, preferably less than 6". Also make sure that the point on the car where the connection is to be made is free of paint and dirt.

Connect the remote terminal of the amplifier to a switchable +12V source.

This connection allows the amplifier to be turned on and off with the power control of the radio. If the radio has a REMOTE output terminal, connect it to the amplifier's terminal marked REM (using a 16 gauge wire or heavier). Now when the radio is turned on, the amplifier will automatically turn on. This connection can also be made to the radio’s Power Antenna wire.

6

Image 7
Contents Mosfet Power Amplifiers Page Keep Your Sales Receipt IntroductionRecommendation Safety Precautions Features and Benefits Stable To 2 Ohm Stereo Mode Excluding CA400M & CA600M Power FusingPower and Speaker Distribution Blocks Adjustable Input SensitivityConnect the amplifier to the cars battery Power ConnectionsMounting Location CH 1 will operate the front right speaker Signal ConnectionsFloating Ground Radio Most Common Type High Level Connections OptionalFour Channel Speaker Connections Speaker ConnectionsSpeaker Connections Bridged 100 F Speaker Connections TRI-MODEFine tune the amplifiers input sensitivity Setting the Crossover and Bass BoostFine Tune the System Select your crossover type and frequencyLook for Solution Trouble Shooting the SystemCA200 CA400 CA600 SpecificationsCA440 CA640 Limited Warranty Warranty Repair Policy Profile Consumer ELECTRONICS, INC Shoemaker AVE