The ACS switch options are:
RCA STEREO: This option provides a stereo output via both left and right output channels from a stereo signal connected to both left and right input RCA inputs.
RCA BRIDGED MONO: This option configures your amplifier to drive one loudspeaker from one unbalanced signal fed to the RIGHT RCA input. The loudspeaker is connected to both channels positive
(+)output terminals, giving an available power in this mode four times the rated output of the amplifier, approximately 460 watts into 8 ohms. Special care must be taken in connecting the input signal and loudspeakers to ensure safe operation and best possible performance.
XLR STEREO: This option provides a stereo output signal from a balanced stereo input signal connected to both the left and right XLR inputs. All the advantages of balanced line transmission will be realised with good rejection of noise and some freedom from earth or ground loops (hum).
XLR BALANCED MONO: In this mode both channels of your Plinius
BALANCED/UNBALANCED SIGNALS
Balanced or unbalanced input options will depend on the type of signal available from your preamplifier or other equipment. The Plinius
BALANCED LINE is normally used to transmit signals in a professional environment. Because balanced line effectively reduces or eliminates noise
UNBALANCED leads such as single ended, RCA or coaxial are common and are used in the majority of audio signal systems. The terminal plug and socket are most commonly called RCA and can be found on your Plinius
OUTPUT TERMINALS - STEREO
Output connections for the loudspeakers are provided on the left and right hand side of the rear panel. Two parallel pairs of binding posts for each channel are fitted – these provide ease of use with
10