Ergotron AOC LM720 user manual Connecting the Wires Using the Power Cord Supplied

Page 6

Before You Operate the Monitor AOC LM720

Connecting the Wires Using the Power Cord Supplied

1.Connect the built-in video cable into the 15-pin connector on the back of your computer and tighten the two screws.

2.Connect the power cord into the power adaptor.

3.Plug the other end of the power cord into a grounded AC outlet or UL-approved power strip.

4.Connect the power adapter into the DC IN socket on the back of the monitor.

Caution: Make sure the power cord is the correct type that is required in your area. This LCD monitor has a universal power supply that allows operation in either 100/120V AC or 220/240V AC voltage areas (no user adjustment is required).

If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

AOC LM720

6

v2_123102

 

Page 5 Page 7
Image 6
Page 5 Page 7
Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Installing & Removing the Base General Features Package ContentsBefore You Operate the Monitor AOC LM720 Connecting the Wires Using the Power Cord Supplied See next page for further installation instructions Install An Optional Wall Mounting Arm Not supplied Adjusting the Viewing Angle How to Install INF & ICM FileOperating Instructions Front Panel ButtonsAdjusting the OSD Settings How to Optimize the DOS-mode Plug & Play DDC1/2B FeatureDOS-mode Technical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution VerticalSpecifications AppendixEPA Energy Factory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description
Top Page Image Contents