Ergotron AOC LM520 user manual Connecting the Wires Using the Power Cord Supplied

Page 6

Before You Operate the Monitor AOC LM520

Connecting the Wires Using the Power Cord Supplied

1.Connect the built-in video cable into the 15-pin connector on the back of your computer and tighten the two screws.

2.Connect the power cord into your LCD monitor's Power Adapter.

3.Connect the Power Adapter to your monitor.

4.Plug the other end of the power cord into a grounded AC outlet or UL-approved power strip.

Caution: Make sure the power cord is the correct type that is required in your area. This LCD monitor has a universal Power Adapter that allows operation in either 100/120V AC or 220/ 240V AC voltage areas (no user adjustment is required).

If the AC outlet is not grounded (with three holes), install the proper grounding adapter (not supplied).

AOC LM520

6

v3_123102

Page 5 Page 7
Image 6
Page 5 Page 7
Contents User’s Manual Inch TFT LCD MonitorFor Your Safety FCC StatementPrecautions Using the Right Power Cord Special Notes on LCD MonitorsGeneral Notes Before You Operate the Monitor AOC LM520 EPA Energy StarConnecting the Wires Using the Power Cord Supplied Adjusting the Viewing Angle Before You Operate the Monitor AOC LM520 Install An Optional Wall Mounting Arm Not Supplied Operating Instructions Front Panel ButtonsAdjusting the OSD Settings Plug & Play DDC1/2B Feature How to Install INF & ICM FileTechnical Support FAQ Problem Possible SolutionError Message Possible Solution Resolution Chart Resolution Vertical Pixels FrequencySpecifications AppendixOptimal Viewing Mode 1024 x 768 @ 60Hz Factory Preset Timing Table Standard Resolution Horizontal Vertical Pixels FrequencyConnector Pin Assignment Pin Number Description
Top Page Image Contents