Step 2: Connect the Component to HDMI Adapter
1.Connect the included component video cable and digital audio cable between the Sony changer’s outputs and the inputs on the video adapter.
2.Connect your HDMI cable between the video adapter HDMI output and the first HDMI input on the Vision.
3.Insert the DC side of the power supply into the video adapter.
4.Insert the AC side of the power supply into the wall outlet.
Step 3: Connect the Keyspan USB to Serial Adapter
1.Connect the included USB cable between the top USB port on the rear of the Vision and the Keyspan Serial adapter.
2.Connect a null modem (female to female)
Step 4: Configure the Sony Changer’s Back Panel Switches
1.Make sure the COMMAND MODE switch is set to 1.
2.Make sure the COMPONENT VIDEO OUT switch is set to
PROGRESSIVE.
Step 5: Turn on your Vision
Press and release the power button on the front panel of the Vision and wait for it too boot up. The boot process is complete when the power LED changes to blue.
Step 6: Lookup Changer Discs
After Vision is fully running, you can start the disc lookup process. To initiate the initial lookup of all of the DVDs in the changer you must open and close the changer door using the Sony’s front panel OPEN/CLOSE button. Vision will then begin to identify all of the changer discs. This may take up to an hour and a half for a full changer.
Audio Configuration
Configure the Sony Changer’s Digital Audio Settings
The Sony
Follow these steps using the SONY CHANGER REMOTE to set the correct audio settings on the changer:
1.While a movie is playing form the changer press STOP.
2.Press the DISPLAY key to show the changer’s on screen menu system.