Dialogic 05-2548-006 manual Dlservices cli start, Msml

Issues Sorted by Type, Dialogic® Multimedia Platform (Continued)

Issue Type	Defect No.	SU	Product or	Description
		No.	Component
Known	IPY00038149		hardware	Shut down is not supported by opening of the Dialogic®
				Multimedia Blade latch. The blue LED (hotswap LED)
				on the blade will blink indefinitely but never turn solid to
				indicate shut down complete.
				Workaround: To shut down the blade, log on locally
				through the serial port or connect over the network and
				initiate a shutdown. The blade can be initialized by
				removing and reseating in the chassis.
Known	IPY00038148		hardware	Activation and de-activation via the shelf manager is not
				supported on the Dialogic® Multimedia Blade latch. The
				blue LED (hotswap LED) on the blade will blink
				indefinitely but never turn solid to indicate shut down
				complete.
				Workaround: To shut down the blade, log on locally
				through the serial port or connect over the network and
				initiate a shutdown. The blade can be initialized by
				removing and reseating in the chassis.
Known	IPY00038147		hardware	If the Dialogic® Multimedia Blade is deactivated using
				the shelf manager, the kernel panics while shutting
				down the system services and does not complete the
				hot swap extraction cycle.
				The craftsperson can then remove and/or restart the
				blade.
Known	IPY00036028		hardware	The PSTN Rear Transition Module (RTM) generates
				major events to the shelf manager stating that the
				sensor “RTM +1.0 V” went over the upper critical limit.
Known	IPY00036026		hardware	The Dialogic® Multimedia Blade generates major
				events to the shelf manager stating that the sensor
				“SBC +1.1V SUS” went over the upper critical limit.
Known	IPY00032623		MSML	‘audiosamplerate’ and ‘audiosamplesize’ must be
				specified by the MSML application server when playing
				a .WAV file from an offset.
Known	IPY00034143		PSTN call control	When using all 496 time slots on 16 E1 trunks, there is
				a 1% failure rate with DTMF digit detection.
Known	IPY00034168		CLI	On a CLI shutdown (by dlstop), the CLI session port is
(permanent)				not immediately released. If a user does a dlstop
				followed by a dlstart too quickly (within 20 seconds), the
				dlstart may not be able to start the CLI session.
				Workaround: If the CLI agent start part of dlstart fails,
				then the workaround is to do the following from a
				terminal window after around 20 seconds:
				dlservices cli start
				If it doesn't work immediately, try again in a few
				seconds. This will start the CLI agent and user will be
				able to use telnet again.

14Dialogic® Multimedia Software for ATCA Release 1.0 Release Update, Rev 06 — January 23, 2008 Dialogic Corporation