DeWalt WRT160NL manual Bottom Panel, Horizontal Placement

Chapter 1						Product Overview
Bottom Panel		Wall-Mounting Placement
		The Router has two wall-mount slots on its bottom
		panel. The distance			between the slots is 152 mm
		(6 inches).
		Two screws are needed to mount the Router.
		Suggested Mounting Hardware
						-3.0 mm
		4-5 mm		1-1.5 mm
						2.5
	Reset  The Reset button is located on the
		††Note: Mounting hardware illustrations are not
	right side of the product label. There are two
		true to scale.
	ways to reset the Router to its factory defaults.
	Either press and hold the Reset button for
			NOTE: Linksys is not responsible for damages
	approximately five seconds, or restore the
	defaults from the Administration > Factory		incurred by insecure wall-mounting hardware.
	Defaults screen of the Router’s web‑based
	utility.	Follow these instructions:
Horizontal Placement		1. Determine where you want to mount the Router. Make
		sure that the wall you use is smooth, flat, dry, and
The Router has four rubber feet on its bottom panel. Place		sturdy. Also make sure the location is within reach of
		an electrical outlet.
the Router on a level surface near an electrical outlet.
		2. Drill two holes into the wall. Make sure the holes are
		152 mm (6 inches) apart.
		3. Insert a screw into each hole and leave 3 mm
		(0.12 inches) of its head exposed.
		4. Maneuver the Router so the wall-mount slots line up
		with the two screws.
		5. Place the wall-mount slots over the screws and slide
		the Router down until the screws fit snugly into the
		wall-mount slots.

152 mm

Print this page at 100% size.

Cut along the dotted line, and place on the wall to drill precise spacing.

Wall-Mounting Template

Wireless-N Broadband Router with Storage Link 2