Mounting KIT Instruction, FCC Compliance Statement

MOUNTING KIT INSTRUCTION

The 16 or 24-port 10/100 Dual Speed Switch is supplied with two mounting brackets, six screws, and four rubber feet for mounting the rack or putting it on a flat surface.

On a flat surface

!Apply four rubber pads to the bottom of the unit.

!Put the switch on the flat surface.

Rack mounting in a rack

!Locate the mounting bracket over the mounting holes.

!Insert the screw through the bracket and into the bracket mounting holes in the switch

!Insert the unit into the 19-inch rack

9	8168
9	1616
	Normal/Uplink

FCC COMPLIANCE STATEMENT

This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the instructions provided with the equipment, may cause interference to radio and TV reception. The equipment has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If you suspect this equipment is causing interference, turn your switch on and off while your radio or TV is showing interference. If the interference disappears when you turn the switch off and reappears when you turn the switch on, something in the switch is causing interference.

You can try to correct the interference by one or more of the following measures:

!Plug the computer which has the equipment installed into a different power outlet so that the equipment and the receiver are on different branch circuits.

!Reorient the receiving radio or TV antenna where this may be done safely.

!If necessary, you should consult the place of purchase or an experienced radio/television technician for additional suggestions.

SAFETY INSTRUTIONS

1.This product should be operated from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local power company.

2.This product is equipped with a three-wire grounding type plug, a plug having a third (grounding) pin. This plug will only fit into a grounding type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the purpose of the grounding type plug.

3.Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord.

4.If an extension cord is used with this product, make sure that the total ampere ratings on the products plugged into the extension cord do not exceed the extension cord ampere rating. Also make sure that the total of all products plugged into the wall outlet does not exceed 15 amperes.

5.Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.

6.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous voltage points or other risks. Refer all servicing to servicing to service personnel’s.