Digi 90000278_B manual Power Jack P7

Page 17

Power Jack (P7)

The power jack accepts 5 volts DC +/- 5% from a regulated power supply. The development board is polarity sensitive. The +5 volts is assumed to be the center contact on connector, and the ground is the outside of the connector barrel, as shown in the following figure.

Digi One EM Hardware Reference

Image 17

Contents Hardware Reference Manual Digi One EM Page Contents Appendix B Digi One EM Certifications About This Guide T r o d u c t i o nIntroducing the Digi One EM Support Information Digi One EM Drawing O u t t h e D i g i O n e E MConnectors Power and Serial Interface P4 Connectors Ethernet Interface P1 LEDs Reset SwitchBlinking 1-1-1 means Overview O u t t h e D e v e l o p m e n t B o a r dDevelopment Board Illustration DB-9 Serial Interface P1 Pin SignalReset Switch SW1 Power Jack P7 CR9 LEDs CR4 CR11SW1 Appendix a D i g i O n e E M Specification s FCC Part 15 Class a Appendix B D i g i O n e E M C e r t i f i c a t i o n sIces 003 Class a Product SafetyDigi One EM Hardware Reference Digi One EM Hardware Reference