Quick Start Guide
PortServer TS W MEI
Wireless Series
What you will need
PortServer TS1 W MEI
shown | Software & |
Documentation |
Ethernet cable not included | PN:(1P) 90000689 A |
1 | Set serial DIP switch according | ||
| to your serial device requirements. Pinouts | ||
| available on back of quick start. | ||
Switch | |||
Settings | |||
2
Connect serial device
| Up/On |
| * | * |
INSTALL | Down/Off |
| ||
1 2 | 3 4 |
|
*If switch 4 is up, termination resistor is connected.
If switch 4 is down, termination resistor is not connected.
3 |
|
|
Connect | 4 |
|
Ethernet | Connect | |
cable |
| power |
supply
| Power (green) |
| steady blinking; seeking or |
| waiting for an IP address |
Applying power with the |
|
Ethernet cable connected, | Signal (yellow) |
will disable wireless access. | RF signal strength indicated by |
brightness of light |
Software &
Documentation
RUN
WIZARD
Insert CD
If you have a UNIX system and it does not use an
Follow wizard
Be sure to check Digi Support for the latest firmware updates at: http://support.digi.com
REBOOT
Applying power with the | 1 |
Disconnect | |
Ethernet cable disconnected, | power |
will enable wireless access. | supply |
© Digi International Inc., 2005.
Digi, Digi International, the Digi logo, the Making Device Networking Easy logo, PortServer, and RealPort
are trademarks or registered trademarks of Digi International, Inc. in the United States and other countries worldwide. All other trademarks are the property of their respective owners.
2
Disconnect Ethernet cable
Congratulations!
Configuration is complete.
Go to the User's Guide
on the CD for more
information.
3
visit us at www.digi.com