Digi 34 manual Introduction, Outline, Assumptions

			Contents
1	Introduction		2
	1.1	Outline	2
	1.2	Assumptions	2
	1.3	Corrections	3
	1.4	Version	3
2	Configuration		4
	2.1	Configure PPP 1 (ADSL)	4
	2.2	Configure PPP 4 (PSTN)	6
	2.3	Configure the Default Routes	8
	2.4	Configure the Firewall	9
	2.5	Save configuration	10
3	Testing		11
	3.1	Simulate a failure	11
4	Configuration Files		11
	4.1	Digi Transport Configuration Files	11
	4.2	Digi Transport Firmware Versions	12

1 INTRODUCTION

1.1 Outline

The document describes how to configure a Digi Transport router to fail over to PSTN when there is a problem with the main ADSL connection. Once the ADSL connection is working again the router will test it by sending pings and then revert back to ADSL and drop the PSTN connection.

This application note uses PPP 4 (PSTN) as the failover interface, however, if the router being configured has ISDN, simply configure PPP 2 (ISDN) instead of PPP 4. The same configuration can be applied to the ISDN interface.

For failover from ADSL to a cellular network, please see Application Note 34a as the configuration is slightly different.

1.2 Assumptions

This guide has been written for use by technically competent personnel with a good understanding of the communications technologies used in the product, and of the requirements for their specific application. Configuration: This application note assumes that the router will be connecting to a cellular network.

This application note applies to;

Models shown: Digi Transport DR64 router with ADSL & PSTN running firmware version 5081.

Other Compatible Models: All Digi Transport products.

Firmware versions: 4905 or later.

2