Functional Test
AC Mode
The UPS delivers power to the loads derived from the utility and maintains proper battery charge. It also regulates the output voltage to within a narrow range.
On-Battery Mode
The UPS operates on battery when the line voltage or frequency has fallen outside the limits. Local users are alerted to this mode of operation by visual and audible indicators. The UPS provides power to the load from the battery and through its inverter and the output voltage and frequency of the UPS are regulated within a narrow range
1.Switch On
Press the power switch on the front panel then the status LCD will light up.
2.Switch Off
Press again the power switch, the status LCD on the front panel will go off.
3.Cold Start / Start on Battery:
This UPS can be turned on even when AC is not present.
Press the power switch on the front panel then the status LCD will light up.
ROUTINE MAINTENANCE AND STORAGE
ROUTINE MAINTENANCE
1.Use dry soft clothes to clean the front panel and plastic parts. Do not use any detergent that contains alcoholic ingredient.
2.The expected lifetime of the battery is around 3 years. Improper operation and harsh environment will reduce the actual lifetime.
3.Unplug the UPS from power inlet if the UPS will not operate for long period of time.
STORAGE
1.First turn off your UPS and disconnect its power cord from the wall outlet. Disconnect all cables connected the UPS to avoid battery drain.
2.The UPS should be stored in a cool dry location.
3.Make sure the battery is fully charged before the UPS is stored.
4.For extended storage in moderate climates, the battery should be charged for 12 hours every 3 months by plugging the power cord into the wall receptacle and turning on the main switch. Repeat it every 2 months in high temperature locations.
TROUBLE SHOOTING
| Problem | Possible Cause | Solution |
| The UPS does | Batteries are not fully | Recharge the battery by leaving the UPS |
| charged. | plugged in. |
| not perform |
| expected | Battery is slightly worn out. | Contact CyberPower Systems at |
| runtime. |
| service@cyberpower-eu.com |
| | |
| | | |
| | The on/off switch is | Turn the UPS off. Wait 10 seconds and |
| | designed to prevent |
| | damage by rapidly turning it | then turn the UPS on. |
| | off and on. | |
| The UPS will not | The unit is not connected to | The unit must be connected to a |
| turn on. | an AC outlet. | 220-240V 50/60Hz outlet. |
| | The battery is worn out. | Contact CyberPower Systems at |
| | service@cyberpower-eu.com |
| | |
| | Mechanical problem. | Contact CyberPower Systems at |
| | service@cyberpower-eu.com |
| | |
| | Circuit breaker is tripped | Turn the UPS off and unplug at least one |
| | piece connected equipment. Unplug the |
| | due to overload | power cord of the UPS then press the |
| Outlets do not | | circuit breaker knob. |
| | |
| provide power to | Batteries are discharged | Allow the unit to recharge for at least 4 |
| equipment | hours. |
| |
| | | |
| | Unit has been damaged by | Contact CyberPower Systems at |
| | a surge or spike. | service@cyberpower-eu.com |
| | | |
| | The serial/USB cable is not | Connect the serial/USB cable to the UPS |
| | unit and an open serial port on the back |
| | connected. | of the computer. You must use the cable |
| | | that came with the unit. |
| PowerPanel® | The serial/USB cable is | Try another serial/USB port of your |
| connected to the wrong |
| Personal Edition | port. | computer. |
| is inactive (all | | |
| | Shutdown your computer and turn the |
| icons are gray). | The unit is not providing |
| UPS off. Wait 10 seconds and turn the |
| | battery power. |
| | UPS back on. This should reset the unit. |
| | |
| | The serial cable is not the | You must use the cable included with the |
| | cable that was provided with |
| | unit for the software. |
| | the unit. |
| | |
CyberPower warrants to you, the original purchaser, that CyberPower UPS will be free from defects in design, assembly, materials and workmanship for two years ( battery is only one year) from the date of original purchase. Any warranty services, please contact your local dealers or distributors.
TECHNICAL SPECIFICATIONS
| Model | | Value 1200E | Value 1500E | Value 2200E |
| Capacity | (VA) | 1200VA | 1500VA | 2200VA |
| Capacity | (Watts) | 720W | 900W | 1320W |
| Input | | | | |
| Input Voltage Range | | 160VAC~270VAC | |
| Frequency Range | 50/60Hz +/-3Hz(Auto Sensing) |
| Output | | | | |
| On Battery Output | Simulated Sine Wave at 230Vac +/-7% |
| Voltage | |
| | | | |
| On Battery Output | | 50/60 Hz | |
| Frequency | | | |
| | | | |
| Overload Protection | On Utility: Circuit Breaker, On Battery: Internal Current Limiting |
| Physical | | | | |
| Total # of UPS | | (6) IEC 320 C13 | |
| Receptacles | | |
| | | |
| Maximum Dimensions | 32.6cm(L) ⋅ 14.cm(W) ⋅ 18cm(H) |
| Weight | | 13.0 kg / 28.6 Lbs | 14.3 kg / 31.5 Lbs | 15.4 kg / 33.9 Lbs |
| Battery | | | | |
| Sealed Maintenance | 12V / 7Ah x2 | 12V / 8.5Ah x2 | 12V / 9Ah x2 |
| Free Lead Acid Battery |
| | | |
| Typical Recharge Time | | 8 Hours | |
| Warning Diagnostics | | | |
| Indicators | | Power On, UPS Status Display, Capacity Display, Digital Value |
| | | | Display | |
| Audible Alarms | On Battery, Low Battery, Overload |
| Environmental | | | |
| Operating Temperature | +32°F to 104°F ( 0°C to 40°C ) |
| Operating Relative | 0 to 95% NON-CONDENSING |
| Humidity | |
| | | | |
| Communication | | | |
| PowerPanel® Personal | Windows 98/ME/2000/NT/XP/Vista |
| Edition Software |
| | | |
| Management | | | |
| Auto-Charger | | Yes | |
| Auto-Restart | | Yes | |
| USB | | | Yes | |
DEFINITIONS FOR ILLUMINATED LCD INDICATORS
LCD Indication
Line mode
Select SW | | UPS Status Display | | | Capacity Display | | Digital Value Display | |
| | | | | | | | | | | |
Press | | | | | | Load | Battery | Input | Output | Run | % | % |
| | | | | Cap. | Cap. | Voltage | Voltage | Time | of Load | of Batt. |
| | | | | | | | | | | | |
Initial | V | X | -- | X | | V | X | | V | | | |
1st | V | X | -- | X | | V | X | | | V | | |
2nd | V | X | -- | X | | V | X | | | | V | |
3rd | V | X | -- | X | | X | V | | | | | V |
4th | V | X | -- | X | | V | X | V | | | | |
5th(Return) | V | X | -- | X | | V | X | | V | | | |
Press >3sec | V | X | V | X | | -- | -- | -- | -- | -- | -- | -- |
(Sound Disable) | |
| | | | | | | | | | | |
Press >3sec | | | | | | | | | | | | |
again | V | X | X | X | | -- | -- | -- | -- | -- | -- | -- |
(Sound Enable) | | | | | | | | | | | | |
| | | | | | | | | | | | |
(Overload) | V | X | -- | V | | -- | -- | -- | -- | -- | -- | -- |
“V” : Illuminated, | “X” : Not Illuminated, | “--“ : Either | | | | | | | |
Battery mode
Select SW | | UPS Status Display | | | Capacity Display | | Digital Value Display | |
| | | | | | | | | | | |
Press | | | | | | Load | Battery | Input | Output | Run | % | % |
| | | | | Cap. | Cap. | Voltage | Voltage | Time | of Load | of Batt. |
| | | | | | | | | | | | |
Initial | X | V | -- | X | | X | V | | V | | | |
1st | X | V | -- | X | | X | V | | | V | | |
2nd | X | V | -- | X | | V | X | | | | V | |
3rd | X | V | -- | X | | X | V | | | | | V |
4th | X | V | -- | X | | X | V | V | | | | |
5th(Return) | X | V | -- | X | | X | V | | V | | | |
Press >3sec | X | V | V | X | | -- | -- | -- | -- | -- | -- | -- |
(Sound Disable) | |
| | | | | | | | | | | |
Press >3sec | | | | | | | | | | | | |
again | X | V | X | X | | -- | -- | -- | -- | -- | -- | -- |
(Sound Enable) | | | | | | | | | | | | |
| | | | | | | | | | | | |
(Overload) | X | V | -- | V | | -- | -- | -- | -- | -- | -- | -- |
“V” : Illuminated, | “X” : Not Illuminated, | “--“ : Either | | | | | | | |
For more information, visit eu.cyberpowersystems.com or contact
CyberPower Systems B.V.
Flight Forum 3545 5657DW Eindhoven The Netherlands
Tel: +31 40 2348170, E-MAIL: sales@cyberpower-eu.com
CyberPower Systems Inc. (USA) 4241 12th Avenue East, Suite 400, Shakopee, MN 55379, U.S.A. Tel: +1 952 4039500, Fax: +1 952 4030009, E-MAIL: sales@cyberpowersystems.com
Entire contents copyright ©2004 CyberPower Systems B.V., All rights reserved. Reproduction in whole or in part without permission is prohibited. PowerPanel® and PowerPanel® Plus are trademarks of CyberPower Systems (USA) Inc.
