Edimax Technology N-9210TX-64 Trouble-shooting, „ 10 Link/Activity, „ 100 Link/Activity

Page 7

4

Trouble-shooting

4

 

If you experience any problems with the adapter, first make sure the appropriate driver is loaded, the proper cable is connected to the adapter port and the hub/switch complies with the adapter specification, such as 10Mbps 10BaseT, 100Mbps 100BaseTX and 1000Mbps 1000BaseT, then check the LED.

The adapter provides three LEDs to indicate network status.

„10 Link/Activity

The LED indicates if the 10Mbps UTP has been LINK ok or not. When the light is OFF, it indicates that the 10Mbps UTP port has not been connected or LINK not ok. When the light is ON, it indicates that the 10Mbps UTP port LINK ok. When the light is BLINKING, it indicates that there is traffic flow on the network which the adapter is connected to.

„100 Link/Activity

The LED indicates if the 100Mbps UTP has been LINK ok or not. When the light is OFF, it indicates that the 100Mbps UTP port has not been connected or LINK not ok. When the light is ON, it indicates that the 100Mbps UTP port LINK ok. When the light is BLINKING, it indicates that there is traffic flow on the network which the adapter is connected to.

„1000 Link/Activity

The LED indicates if the 1000Mbps (Gigabit) UTP has been LINK ok or not. When the light is OFF, it indicates that the 1000Mbps UTP port has not been connected or LINK not ok. When the light is ON, it indicates that the 1000Mbps UTP port LINK ok. When the light is BLINKING, it indicates that there is traffic flow on the network which the adapter is connected to.

5

Image 7
Contents Gigabit Ethernet Adapter FCC Compliance Statement Introduction Features & Benefits Features & SpecificationsTechnical Specification Hardware Installation InstallationDriver Installation „ 1000 Link/Activity Trouble-shooting„ 10 Link/Activity „ 100 Link/ActivityTrademarks