Dell 6200 manual April, Viewing The Mstp Status, show spanning-tree mst configuration

Page 18

show spanning-tree mst configuration

MSTP INTEROPERABILITY OF THE DELL™ POWERCONNECT™ 6200 SERIES SWITCHES WITH CISCO IOS AND CISCO CATOS-BASED SWITCHES

To perform the same configuration by using the Web interface, go to the Switching > VLAN > VLAN Membership page, and add port 5 as an access ports in VLAN 10. Ethernet traffic on this port will be untagged.

VIEWING THE MSTP STATUS

You can view the MSTP Region configuration on the three bridges by using the following command:

show spanning-tree mst configuration

The command is the same on the Dell and Cisco switches.

APRIL 2008

18

Image 18

Contents Information in this document is subject to change without notice MSTP INTEROPERABILITY OF THE DELL POWERCONNECT 6200 SERIES SWITCHESWITH CISCO IOS OR CISCO CATOS BASED SWITCHES CLI CONFIGURATION CONTENTSVOICE VLAN CONFIGURATION WEB CONFIGURATIONDELL POWERCONNECT 62XX MSTP FUNCTIONAL DESCRIPTION APRILMSTP Port State Admin Port StateSTP Port State Active TopologyACTIVE TOPOLOGY ENFORCEMENT Figure 2 Example FID to MSTI AllocationFigure 3 Example Resultant VID to MSTI Allocation MSTP CLI COMMANDS CONTROL PACKET BEHAVIORshow spanning-tree OPERATION IN THE NETWORK Figure 4 Small Bridged NetworkFigure 5 Single STP Topology Figure 6 Logical MSTP Environment Command SAMPLE SETUP AND CONFIGURATIONSCONFIGURING BRIDGE BrA CLI DescriptionCONFIGURING BRIDGE BrA WEB INTERFACE APRIL APRIL APRIL 10. Click Apply Changes 12. Click Show All to access the MSTP Settings Table CONFIGURING BRIDGE BrB CONFIGURING BRIDGE BrCCONFIGURING EDGE DEVICES show spanning-tree mst configuration Bridge BrC Cisco Bridge BrA DellBridge BrB Dell ADDITIONAL MSTP STATUS INFORMATIONPriority APRIL Bridge BrA DellAPRIL ADDITIONAL INFORMATION AND SCALABILITY WITH MORE REGIONS Figure 7 Multiple MSTP Regions Figure 8 Multiple MSTP Region Interactions