Freedom9 80 user manual Save Event Log, Telnet

freeView Power 80 User Manual

Figure 33 – Event Log Page

The possible events for the freeView Power 80 are:

•RPM Connection Lost: One of the freeView Power 80 units in the stack is unavailable.

•Outlet On: A specific outlet has been turned on.

•Outlet Off: A specific outlet has been turned off.

•Outlet Reboot: A specific outlet has been rebooted.

•Outlet Fault: A specific outlet is defective.

With the freeView Power M2 module, the following events can occur:

•Environmental Temperature Overrun: The environment sensor reported a temperature level above the maximum allowable temperature level.

•Environmental Temperature Underrun: The environment sensor reported a temperature level below the minimum allowable temperature level.

•Environmental Humidity Overrun: The environment sensor reported a humidity level above the maximum allowable humidity level.

•Environmental Humidity Underrun: The environment sensor reported a humidity level below the minimum allowable humidity level.

4.2.15Save Event Log

Clicking on the Save Event Log link will allow you to download the current event log to your computer in comma delimited format.

4.3Telnet

To connect to the freeView Power 80 using Telnet, follow these steps:

1.In Windows, click the Start Menu, then click “Run…” (Figure 34)

2.Type in “telnet <ip address>” where <ip address> is the IP address of the freeView Power 80.

29