7.Loosen the captive screws on each side of the PIM faceplate.
8.Grasp the handles on each side of the PIM faceplate and slide the PIM out of the router. Place it in the electrostatic bag or on the antistatic mat.
9.If you are not reinstalling a PIM into the emptied slot, install a blank PIM panel over the slot to maintain proper airflow.
Figure 1: Removing a PIM
J4300 | 5/0SLOT |
|
|
| EJECT |
| |
|
|
| |
| 3/0 | IN | PACT FLASH |
| SLOT | USE | COM |
| TE |
| |
|
| RT 1 |
|
1/0SLOT |
|
|
|
|
|
|
| STATUS |
ALAR | M | CO | NFIG | LIARES |
| PORT | 1 | |
|
| PORT 0 | S |
| ||||
POWER | ON |
|
|
|
| |||
|
|
|
| STATU |
|
| ||
Captive screws
g003539
Installing a PIM
To install a PIM (see Figure 2):
1.Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the Services Router is disconnected from earth ground. For more information about ESD, see the
2.Press and release the power button to power off the router. Verify that the POWER ON LED blinks and then turns off.
3.Align the notches in the connector at the rear of the PIM with the notches in the PIM slot in the Services Router, and then slide the PIM in until it lodges firmly in the router.
CAUTION: Slide the PIM straight into the slot to avoid damaging the components on the PIM.
Installing a PIM |
| 3 |
|