B&B Electronics TS W Family quick start Ioscan -funC disk, Mnt/cdrom /cdrom, Pfsmountd& pfsd

Accessing the CD from a UNIX System

Insert CD in system CD drive

1

UNIX Software &

Documentation

2

Determine your CD device

Common names for CD-ROM devices:

NAME	EXAMPLE
/dev/cdrom	/dev/cdrom
/dev/cdrom/cdromn	/dev/cdrom/cdrom1
/dev/cdn	/dev/cd0
/dev/dsk/cktmdn	/dev/c1t2d0

To list descriptions of devices: AIX: lscfg

HPUX: - Make sure you have administrator privileges and your PATH includes /usr/sbin

ioscan -funC disk

Solaris: Most Solaris systems use an auto-mounter.

See the man page on vold: man vold

If your system auto mounts the CD, skip to step 5. Auto Mount programs may use the volume information to define a mount point. If the CD volume label is "Digi" then the mount point may be /cdrom/digi

3

Identify the mount-directory.

Some common pre-existing mount points:

/mnt/cdrom /cdrom

Or create your own: mkdir /mnt/mycdrom

HPUX - Check to see if pfs is running ps -ef grep pfs

If not, start the daemons:

pfs_mountd&; pfsd&

4

Mount the CD by entering one of the commands from the following table:

Operating	Command
System
AIX	mount -r -v cdrfs device mount-directory
	do not use mount, it will not operate correctly
*HPUX	pfs_mount device mount-directory
	See man pages for pfs and pfs_mount for more
	information.
Linux	mount device mount-directory
SCO	mount -r -F cdfs device mount-directory
UnixWare
SCO	mount -r -f ISO9660 device mount-directory
OpenServer
Solaris	mount -F hsfs device mount-directory
(Intel	Most systems use an auto-mounter. See the man page
& SPARC)	on vold: man vold

device is the path to the device file assigned to the cdrom drive, mount-directoryis the directory where the Digi CD is mounted

*HPUX When finished, leave the CD directory and pfs_umount

cd

pfs_umount mount-directory

(If you inadvertenly use umount instead of pfs_umount, kill the pfs daemons to remove the CD-ROM.)

5

Navigate to mounted CD directory, enter: ./setup

If you see DISPLAY permission errors when running the CD, you may want to verify your DISPLAY variable is set.

To set the DISPLAY variable:

DISPLAY=localhost:0.0; export DISPLAY

AND/OR

xhost +localhost