Chapter 3 Setting up the security gateway for configuration
This chapter describes how to set up the security gateway addressing and remote connectivity capabilities in preparation for remote configuration using the VPNmanager software. This preliminary configuration is performed using a browser on your workstation connected to the security gateway’s Private Port. The following procedure assumes that the security gateway has been physically installed on the network, according to the instructions provided in Chapter 2.
The security gateway setup consists of two basic steps:
•Establishing connectivity between the workstations or IP devices on your local network with the security gateway’s Private Port(s),
•Setting up the security gateway’s Public Port to reach the Internet.
When the security gateway is initially installed and connected to your local LAN, it is provisioned with a default IP address for the DHCP server (serving the Private Ports) allowing you to access the device through a web browser on your workstation. Through the web interface, you can assign a static IP address for the Public Port, password, etc. Once this has been done, the security gateway can be incorporated into your Virtual Private Network (VPN) by your VPN administrator using remote configuration software from a central location.
March 2004 | Setting up the security gateway for configuration 23 |