Table 2.1 - 232DRIO Terminal Blocks
Blue | | Black |
Pin # | Function | Pin # |
| | |
1 | - Ground Input Power | 1 |
2 | +12Vdc Input Power | 2 |
3#2 N/C-Normally Closed
4#2 N/O-Normally Opened
5#2 C-Common
6#1 C-Common
7#1 N/C-Normally Closed
8#1 N/O-Normally Opened
Function
Opto-Isolated Input
Opto-Isolated Input
Non-polarized
0-30 Vdc/Vac
Serial Port Connections
In order to communicate to the 232DRIO module it must be connected to an RS-232 serial port. The unit is designed for a baud rate of 9600, so the serial port must be set for this rate. A data format of 8 data bits, 1 stop bit and no parity is used. The 232DRIO is configured as a DCE device (See Table 2.2). If your communications equipment is configured as a DTE device, such as a standard IBM PC serial port, the 232DRIO should be connected using a “straight through” DB-25 cable or a standard DB-9 to DB-25 cable adapter as shown in Table 2.3. If your communications equipment is configured as a DCE device, such as a modem, the 232DRIO should be connected using a “null modem” cable (see Table 2.4).
Table 2.2 – RS232 Connector Pinout
DB-9S | | Signal |
| Direction at |
Pin # | Signal | 232DRIO |
2 | Receive Data (RD) | Output |
3 | Transmit Data (TD) | Input |
5 | Signal Ground (SG) | ------ |
9 | Power pin | Input |
| | |
Notes
Required
Required
Required
Can be wired to
power unit
232DRIO-0308 Manual | 7 |
B&B Electronics -- | PO Box 1040 -- Ottawa, IL 61350 |
PH (815) 433-5100 -- FAX (815) 433-5104 |
