Optimus 120-1725 manual Routing Speaker Wire, Mounting the Speakers

Three-Way Bass Reflex Car Speaker		System	Faxback Doc. # 38064
(120-1725)	Wiring	the Speakers

Connect two speakers to your auto sound system as shown.

NOTES:

If your autosound system has a front-to-rear fader, follow the instructions in the audio component's manual for the correct speaker connections.

To ensure proper phasing, match the speaker wires to the corresponding red (+) or black (-) speaker terminals. Improper phasing can cause poor bass response.

CAUTIONS:

Do not connect any of your speaker wires to chassis ground. Use all four wires to connect the speakers to your vehicle's autosound system.

Do not connect four speakers to your car stereo/amplifier unless it is designed for a four speaker connection. See your stereo/amplifier's owner's manual for instructions.

ROUTING SPEAKER WIRE

Avoid routing speaker wire near moving parts or sharp edges. You can usually route it along the wiring channel beneath the vehicle's door facings by carefully removing the molding that holds the carpet in place. After routing the speaker wire, replace the molding.

MOUNTING THE SPEAKERS

After you have connected the speakers and turned on your autosound system to ensure that everything is working properly, turn off your autosound system and mount the speakers.

1.Select a flat area (such as your car's rear deck) for the mounting surface. The surface should be sturdy enough to support the weight of the speakers.

2.Use the speaker cabinet's base as a template to mark the desired