Avaya P114T manual Rack Mounting, P110 rack mounting arrangement

Page 12

Chapter 2

Installation

Rack Mounting

P110 switches slot into a standard 19-inch rack.

Remove the rubber legs from the base of any switch that is to be rack mounted. Place the switches in the rack, and then connect the P110 Exoplane, as follows:

1.Snap open the ends of the front panel to reveal the fixing holes.

2.Slot the switch into the rack. Insert the switches into the rack so that the switches in a logical stack lie directly on top of each other. Ensure that the P110 screw holes are aligned with the rack hole positions exactly as shown in Figure 3. Stacking them in this way will allow the switches to be easily connected using the Exoplane cables.

3.Secure the switch in the rack using the screws. Use one screw on each side. Do not overtighten the screws to avoid damaging the plastic.

4.Connect the Exoplane cables, as described above, and as illustrated in Figure 2.

5.Snap closed the hinged ends of the front panel.

Figure 3 P110 rack mounting arrangement

10

P114T Stackable Switch Installation Guide

Image 12
Contents Avaya P114T Page Important information Nicht Blockiert sind.6 Overview DescriptionPage Installation Setting the DIP switchesDIP Switches on the P114T Stackable Switch Installing the P114T Stackable Switch Standalone Operation Plug ‘n’ PlayCabling Requirements Chapter Installation Rack Mounting P110 rack mounting arrangementChapter Installation PWR