Bay Technical Associates Fiber Media Adapter manual Installing a Media Adapter in a BayStack Hub

Installing a Media Adapter in a BayStack Hub

The BayStack 10BASE-FL RDN Media Adapter is installed in a slot on the front of the BayStack 10BASE-T Hub.

To install a media adapter, follow these steps:

1.Unplug the BayStack 10BASE-T Hub power cord from the AC power source.

2.Remove the filler panel from the media adapter slot on the front panel of the hub.

3.Install the media adapter into the media adapter slot.

a.Align the media adapter with the card guides and gently slide in the media adapter until you feel it align with the connector on the hub motherboard.

b.Firmly push the media adapter into the connector.

CAUTION: Do not force or overtighten the captive retaining screw on the media adapter.

c.Tighten the captive retaining screw on the media adapter by turning the screw clockwise.

4.Reconnect the power cord.

The hub powers up and performs a self-test.

5.Make appropriate cable connections.

For cabling information, see the section earlier in this guide that refers to the media adapter you are installing.

10 893-863-A