Buffalo Technology WHR-G300N-US user manual Connecting Wireless Clients to the Access Point

Page 12

Connecting Wireless Clients to the Access Point

To connect wireless devices to the AirStation, you may either enter the SSID and encryption key manually, or you can use AOSS. For more information on AOSS, see pages 14 and 15.

Consult your wireless clients’ manuals for instructions on configuring them manually. You can get SSID and encryption information from the AirStation’s

initial setup screen, as shown above. By default, encryption is not enabled (“open”).

If you prefer to use encryption and/or a different SSID, you may change these default settings under the Wireless Config Tab.

12

Image 12

Contents Wireless N Router & AP Table of Contents Introduction System RequirementsInitial Setup Placing Your AirStation Wall Mounting Wall Mounting Connecting your AirStation Setup Log in to the Configuration Tool Detecting Your Broadband Connection Connecting Wireless Clients to the Access Point Basic Setup Navigating the Menus Initialize/Reboot Aoss Aoss Aoss Notes Some things to keep in mind with AossRouter/Access Point Mode Encryption and Security Encryption and Security Connecting your Wireless Clients Connect Connecting to a Preexisting Network Specifications WHR-G300N AirStation SpecificationsRegulatory Information Troubleshooting Common ProblemsDiag LED Activity Table Other Problems Glossary Glossary Glossary To hardware that requires further manual configuration Glossary UDP User Datagram Protocol a Glossary FCC / CE Information Federal Communication Commission Interference StatementImportant Note FCC Radiation Exposure Statement Important Note Radiation Exposure Statement EU countries not intended for use Page Environmental Information Warranty Information Contact Information North America General InquiriesContact Information Europe GPL Information GPL Information Europe 300* High Speed Mode