Buffalo Technology WZR-G108 setup guide Additional Aoss Information

◗Now that the WRZ-G108 and wireless client

adapter are installed, you can use AOSS to configure them.

◗To begin the configuration, press the INIT/

AOSS button on the back of the WZR-G108 chassis until the AOSS LED on the front begins to flash.

AOSS Mode is now active.

Note: AOSS mode will stay active for a period of two minutes. This is the time-slot required to initiate the wireless client adapter.

Note: Please let go of the button immediately after the LED start flashing. If you press the button for more than 6 seconds, not AOSS but INIT mode become active.

◗Refer to your wireless client adapter's AOSS supplement to initiate the wireless client adapter's AOSS mode.

◗Once the client adapter has begun communicating with the AOSS router, the AOSS client will report a successful AOSS connection. This indicates that the AOSS process has begun and the two devices are configuring themselves. At this time, the AOSS Light on the WZR-G108 will become solid. Please refer to your wireless client adapter's supplement for the remainder of the setup.

Additional AOSS Information:

◗Only one AOSS wireless client adapter can be configured to the AOSS access point at a time. Thus, the button will need to be repressed for each additional AOSS wireless client adapter that will be connected.

◗It is not necessary to AOSS client devices that have already been configured via AOSS, unless significant changes have been made to the wireless network.

◗Do not attempt to configure two separate AOSS networks at the same time, as it may cause undesired configurations.

◗If an undesired client has connected via AOSS, it can be disconnected from within the WZR-G108's advanced configuration AOSS menus.

11