Bogen TMA812 specifications Inset

Page 6

4Attach Speaker Mounting Assembly to Stationary Mounting Bracket

A)Place Speaker Mounting Assembly on the Stationary Mounting Assembly by putting the FRONT TABS of Speaker Assembly into the two FRONT CATCH slots of the Mounting Assembly (see INSET 1).

B)With both Front Tabs hooked securely into both Front Catch slots, gently rotate Speaker Assembly back until both REAR TABS “snap” into both REAR CATCH slots (see INSET 2). When properly engaged, this will provide TEMPORARY support for the Speaker Assembly.

DO NOT LEAVE SPEAKER IN THIS POSITION WITHOUT COMPLETING THE INSTALL PROCEDURES SHOWN WITHIN SECTION 5.

IMPORTANT: BE SURE THAT ALL TABS AND CATCH SLOTS ARE PROPERLY ENGAGED BEFORE LETTING GO OF THE SPEAKER ASSEMBLY. SERIOUS INJURY COULD RESULT WITH IMPROPER CONNECTIONS.

ADJUSTABLE

MOUNTING

BRACKET

 

REAR

 

TAB

FRONT

A8/A12

TAB

 

SPEAKER

 

ASSEMBLY

 

 

REAR

 

CATCH

FRONT

 

CATCH

 

STATIONARY

MOUNTING

ASSEMBLY

FRONT

 

TAB

 

REAR

REAR

TAB

FRONT

CATCH

 

CATCH

 

INSET 1

INSET 2

Image 6
Contents TMA812 Tilt M ount Adapter For Near A8 and A12 Loudspeakers TMA812 Tilt Mount Adapter Components Items Included with A8/A12 LoudspeakerAttaching Stationary Mounting Bracket To a Wall or other Flat Surface2Attaching the Mounting Bracket Assembly to a Pole Repeat process for Bottom Hooks and ChainsSpeaker Mounting Assembly Inset 5Speaker Assembly Angle Adjustment and Locking Procedure Pole Mount TOP-DOWN View Wall Mount TOP-DOWN View