Optimus 40-1425 manual Care Maintenance, Specifications

Page 3

40-1425.fm Page 3 Wednesday, August 11, 1999 8:05 AM

2.Be sure the mounting tabs are in place (parallel with the edge of speaker, not pointing outward), then plug the speaker into the mounting hole.

3.Use the four supplied mounting screws to secure the mounting tabs to the wall or ceiling.

4.If desired, tilt the tweeter toward the listening area. You can tilt the tweeter two steps up or down.

Caution: When you move the tweeter, do not touch the thin, vibrating part. Hold only the outer, hard plastic portion.

Do not touch he

5. Replace the grille.

CARE AND

MAINTENANCE

Your speaker is an example of superi- or design and craftsmanship. These suggestions will help you care for it so you can enjoy it for years.

Keep the speaker dry. If it gets wet, wipe it dry immediately. Liq- uid can contain minerals that can corrode electronic circuits.

Keep the speaker away from dust and dirt which can cause prema- ture wear of parts.

Wipe the speaker frame occasion- ally with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents, or strong detergents.

Caution: You might permanently damage your speaker’s grille or speaker elements by cleaning them with a vacuum cleaner. Instead, use a feather duster or soft cloth.

SPECIFICATIONS

Resonant Frequency

55 Hz ±20%

Frequency

 

 

 

Response

...................

65 Hz–25 kHz

Power Handling

50 Watts RMS

Maximum Power

100 Watts

Impedance

............................

8 Ohms

Sensitivity

......................

88 dB ±2 dB

Voice Coil

................................

1 inch

Magnet Size:

 

 

Woofer

31/8 (diameter) ¥

5/8 Inches

Tweeter

13/4 ¥

7/8 ¥

3/8 Inches

Magnet Weight

Woofer 10 oz

 

Tweeter 2.8 oz

Specifications are typical; individual units might vary. Specifications are subject to change and improvement without notice.

3

Image 3
Contents Painting the Frame and Grille Preparing the LocationMounting Speaker Connecting Speaker WireSpecifications Care MaintenanceRadioShack Division of Tandy Corporation Fort Worth, Texas