ATON DHSIP manual Adjusting Analog Audio Source Output Level

Page 20

DHSIP Source Input Wall Plate

Adjusting Analog Audio Source Output Level

Once all connections are made, the Analog Audio Source should be adjusted for clipping (distortion) before the DHSIP is mounted in place.

To adjust the Analog Audio Source Output Level:

1.Ensure that the Analog Audio Source is connected properly.

2.Power up the source and turn on an audible signal (Press PLAY, tune to a station, etc.).

3.Select the Source from the zone’s DHTP1 Touch- pad. If it is a Local Source connected to a DHTP1, select LOCAL. If it is a System Source connected to a DH46X, select the appropriate Source Input on the Zone’s DHTP1.

4.Adjust the zone’s volume to a normal, comfort- able listening level.

5.Observe the CLIP LED on the front of the DHSIP. If it lights up constantly or consistently, the source’s output level is too high and needs to be adjusted.

6.Adjust the GAIN DIP switches according to the following table:

18	©2008 • All rights reserved.

Image 20

Contents Dhsip Page Safety Information Operating Temperatures & EnvironmentsPrecautions Package ContentsFeatures IntroductionFront Dhsip Front CalloutFunction Rear Dhsip Rear CalloutWiring/Installation 568A Wiring StandardInstallation Installing the DhsipConnections Source ConnectionsAudio Source to Dhsip Connections Analog Digital Optical Optical Audio Source to Dhsip Connections Digital OpticalDigital Coaxial Coax Audio Source to Dhsip Connections Digital CoaxialIR OUT IR OUT to Audio Source 5mm Interconnect Cable Rear Connections DHTP1 Ampliﬁed Touch PadDH46X Digital Audio Router Dhsip to DH46X Rear ConnectionsSettings/Adjustment GainAdjusting Analog Audio Source Output Level Setting Function Appendix a Speciﬁcations Limited Warranty Page Placa empotrada de la Entrada de fuente Tecnología al alcance de todosPage Información de Seguridad Temperaturas y ambientes del funcionamientoPrecauciones Contenidos del paqueteIntroducción DetallesFrente Función Posterior 3 4 5 6 Cableado/InstalaciónEstándar de Cableado T-568A Instalación Conexiones Conexiones de fuentesAnalógico Entrada de audio izquierdo/dere- cho «AUDIO L/R» Óptico digital Entrada óptica «OPTICAL IN» Digital Coaxial Entrada coaxial «COAX IN» Salida infrarrojo «IR OUT» Dibujo 3.4 «IR OUT» a la fuente local Emisor IRFuente de Audio Entrada IR Conexiones de atrás DHTP1 «Touchpad» AmpliﬁcadoDH46X Enrutador Audio Digital Ajustes Ajuste los interruptores «GAIN DIP» según la tabla siguiente Ajuste Función Apéndice a Especiﬁcaciones Interruptores «GAIN DIP»Page Garantía limitada Aviso a Nuestros Consumidores Valiosos