ATON DH46X manual Pre-Wiring, Pre-Construction, Retro-Fit Wiring/PostConstruction

Page 11

DH46X 4 Source, 6 Zone Digital Audio Expansion Router

Pre-Construction

In a pre-construction installation, walls and ceilings are open with no drywall installed. This is desirable and allows the installer greater access than in retro-fi t applications.

Before actually running any wire or cable, take the time to look around each room or area of the house and plan your wire paths for maximum effi ciency. Look for routes through uncluttered parts of the stud wall or ceiling that allow you to group all low-voltage (video, speaker wires, Cat- 5, telephone, etc.) wires wherever possible. It is a good practice to label both ends of all cables and to protect wires by tying a plastic bag over the ends.

Note: Do not run low-voltage wires closer than 12" from high-voltage wires. If necessary, cross low-voltage wires at a 90º angle to prevent interference.

Retro-Fit Wiring/PostConstruction

Retro-fi t installations are more diffi cult to complete than pre-construction because walls and ceilings are intact. Typically wires must be fi shed into position through walls, fl oors and ceilings. Holes must be cut; speakers mounted directly in the ceiling or walls with no rough-in brackets and Touch Pads and local source wall plates must be mounted in existing drywall.

Pre-Wiring

DH46X to DHTP1 Touch Pads

The DH46X and all associated components are wired using Cat-5 terminated to the T-568A Wiring Standard (Figure 2-2). When pre-wiring, run lengths of Cat-5 from the pre-determined equipment location (the “head-end”) to each Touch Pad location. The Cat-5 routes all audio, power, IR and status information needed for full system operation.

Note: For maximum performance over long runs (more than 150 ft) run an additional 16AWG 2-conductor wire for external power.

1 2 3 4 5 6 7 8

Shown tab down

1 2 3 4 5 6 78

GREEN/WHITE

GREEN

ORANGE/WHITE

BLUE

BLUE/WHITE

ORANGE

BROWN/WHITE

BROWN

Figure 2-2 : T-568A Wiring Standard

Touch Pads to Speakers

Run 16AWG 2 conductor stranded copper speaker wire between touchpad locations and speaker locations.

© 2008 • All rights reserved.

9

Image 11
Contents DH46X Page All rights reserved Safety InformationCaring For the DH46X Operating Temperatures & EnvironmentsPrecautions Contents Introduction Aton DH46X Accessories FeaturesFront Panel Indicator/Button FunctionDefining Terms Rear Panel Connector FunctionPlanning System Design Overview/ApplicationsDH46X to DHTP1 Touch Pads Pre-WiringRetro-Fit Wiring/PostConstruction Pre-ConstructionExpanded 4 Source, 8-28 Zone System Local Sources to Touch PadsStand-Alone 4 Source, 6 Zone Stand-Alone No DH44 4 Source, 6 Zone SystemExpanded System 4 Sources/24 Zones + Local Sources Expanded Standalone No DH44 4 Source, 6-24 Zone SystemSource Loop Inputs Source Loop ConnectionsDH46X DH44 Auxiliary Power Connector AUX Power OUTDHTP1 Speaker Connections Zone OUT ConnectionsSpeaker Connections Local Sources System ExpansionUSB Port USB Local Source to Dhsip Connections Digital Optical Dhsip Front DhsipAudio Source IR Input # of Chassis Max # of Zones DH44 x DH44 x 1/DH46X x Adding Zones to a DH44 Digital Audio Router