Asante Technologies FriendlyNet user manual 10Base-T Station to Hub Connection

Page 7

Installation

10Base-T Station to Hub Connection

To connect a 10Base-T network station to the FriendlyNet Hub, follow the instructions and diagram below.

▲Important: Use a straight-through network cable. Make sure the length of the cable between the station and hub does NOT exceed 100 meters (including all patch cables and cross-connect wires).

Network cable segments can be connected to, or disconnected from, the hub while the power is on.

1Connect one end of the network cable to an RJ- 45 port on the FriendlyNet Hub. ❶

2Connect the other end of the cable to the net- work station’s Ethernet adapter. ❷

 

 

 

❶

 

 

UPLINK

5

4

3

2

1

straight-through cable

❷

Figure 2-1 Connecting a 10Base-T station to the FriendlyNet

Ethernet Hub

Page 2-2

Page 6 Page 8
Image 7
Page 6 Page 8
Contents FriendlyNet Hub Copyright Notice Table of Contents Introducing the FriendlyNet Ethernet Hub IntroductionPort FriendlyNet Hub Package Contents FeaturesInstallation Overview InstallationBefore You Start 10Base-T Station to Hub Connection Hub to Hub Connection Connecting two FriendlyNet Ethernet HubsMultiple Hub and Station Configuration Wall-mounting a FriendlyNet Ethernet Hub Wall Mounting the FriendlyNet HubCollision LED LED IndicatorsLED Indicators Power LEDOff Link/Activity LEDsEthernet Configuration Ethernet ConfigurationStar Topology FriendlyNet Ethernet Hub Specifications SpecificationsStandards Compliance Contacting Technical Support Technical SupportAsanté TECHNOLOGIES, INC., 821 FOX LANE, SAN JOSE, CA
Top Page Image Contents