Audio Authority HDP-11 user manual Connecting the Hardware

3.2 CONNECTING THE HARDWARE

1.Connect the HDMI source device’s output to the HDMI INPUT connector of the 1381T Transmitter, using a short, high quality, HDMI cable.

2.Connect a correctly terminated and tested Cat 5 cable to the Cat 5 Output A connector of the Transmitter. Connect a second Cat 5 cable to the Cat 5 Output B. Mark the cables at both ends so that you do not inadvertently swap them. Do not connect the AC adapter until the Cat 5 cables are correctly connected to both the transmitter and the receiver.

Again, always test the HDMI source on the intended display with a known good HDMI cable before using the HDP-11. This precaution insures that the source can be (and is) set to a resolution that is compatible with the display, and that both are functioning correctly together.

3.At the remote location, connect the appropriate Cat 5 cables to the Cat 5 Input A and B connectors of the 1381R Receiver. Be careful not to interchange the A and B cables. Cable A must be connected to both the transmitter and the receiver and Cable B must be connected to the B inputs on both devices in most cases, depending on the source.

4.Connect the HDMI OUTPUT of the 1381R to the HDMI input of the video display or other device, using the appropriate cable.

5.Connect the supplied AC adapters first to the 1381T and 1381R and then to the AC outlets.

6.Turn on the source device and video display. The source video signal should appear on the display. If not, consult the Troubleshooting Guide in this manual.

7