Installing Network Drivers
Installing Network Specific Drivers
Novell NetWare 3.x Client
This section shows you how to install Novell NetWare version 3.x ODI client software.
1 | Create a directory named NETWARE on your C drive. | |
| To do this, type the following command at the DOS command | |
| line prompt: | |
| MD | C:\NETWARE |
2 | Insert either the NetWare WSGEN disk that came with NetWare | |
| 3.x or your master workstation disk into drive A. | |
3 | Copy the following three files to the NETWARE directory on your | |
| C drive. | |
| ❏ | LSL.COM |
| ❏ | IPXODI.COM |
| ❏ | NETX.COM |
➪Important:The
4 Remove the NetWare WSGEN or master workstation disk from the floppy drive.
5
6 Copy the NET.CFG and the ODI driver files to the NETWARE directory on your C drive.To do this, type:
COPY A:\NETWARE\NW3.X\CLIENT\NET.CFG C:\NETWARE COPY A:\NETWARE\NW3.X\CLIENT\ASANTPCI.COM C:\NETWARE
7 Check your CONFIG.SYS file to make sure that this line appears:
DEVICE=C:\DOS\SETVER.EXE
If you don’t see it there, type it in, then save the file.
ΔNote:The SETVER.EXE file must be in the C:\DOS directory.
Page