Wireless Broadband Router
OS, Windows 95/98/NT/2000/Me, etc. The product provides a very easy and
Before Configuration
This section describes the configuration required by LAN- attached PCs that communicate with the Wireless Broadband Router, either to configure the device, or for network access. These PCs must have an Ethernet interface installed properly, be connected to the Wireless Broadband Router either directly or through an external Switch, and have TCP/IP installed and configured to obtain an IP address through a DHCP server or a fixed IP address that must be in the same subnet of the Wireless Broadband Router. The default IP address of the Wireless Broadband Router is 192.168.1.1 and subnet mask is 255.255.255.0. The best and easy way is to configure the PC to get an IP address from the Wireless Broadband Router (DHCP client).
Please follow the steps below for PC’s network environment installation. First of all, please check your PC’s network components. The TCP/IP protocol stack and Ethernet network adapter must be installed. If not, please refer to MS Windows relative manuals.
Before you configure this Wireless Broadband Router, you need to know the following default settings:
•Username:admin
•Password:admin
•IP LAN address: (192.168.1.1), Subnet Mask (255.255.255.0)
•IP WAN address:dhcp client
•DHCP Server: enable (192.168.1.100-192.168.1.199)
•SSSID= default, Channel=6, WEP/WAP=disable
9