Atlantis Land A02-F48-4G user manual AC Power, Identifying External Components, Front Panel

50-Port Dual Web Rack Switch

Product Code	A02-MSW2(Fiber module)
Description	Giga Ethernet Fiber Module
Standards	1000BASE-SX
Network Media	50∝m or 62.5∝m multimode optical fibers
Connector	LC

Technology	Connector	Distance
10 Base T	RJ45	100m
100 Base TX	RJ45	100m
1000 Base T	RJ45	100m
1000 Base SX	LC (62.5∝m multimode optical fibers)	275m
1000 Base SX	LC (50∝m multimode optical fibers)	550m

2.5 AC Power

The Switch used the AC power supply 100-240V AC, 50-60 Hz. The power switch is located at the rear of the unit adjacent to the AC power connector and the system fan. The switch’s power supply will adjust to the local power source automatically and may be turned on without having any or all LAN segment cables connected.

2.6 Identifying External Components

This chapter describes the front panel, rear panel, and LED indicators of the Switch.

Front Panel

The figure below shows the front panels of the Switch.

50-port Dual Web Rack Switch

LED Indicator::

Comprehensive LED indicators display the status of the switch and the network (see the LED Indicators chapter below).

Fast Ethernet Ports (Port 1~48):

These ports support network speeds of either 10Mbps or 100Mbps, and can operate in half- and full- duplex transfer modes. These ports also supports automatic MDI/MDIX crossover detection function gives true “plug and play” capability, just need to plug-in the network cable to the hub directly and don’t care if the end node is NIC (Network Interface Card) or switch and hub.

When the port was set to “Forced Mode”, the Auto MDI/MDIX will be disabled.

Gigabit Ethernet Ports (Port 49~50)::

6