Atmel STK502 manual Section Complete Schematics

Page 27

Section 6

Complete Schematics

On the following pages the complete schematics and assembly drawing of the STK502 revision B are shown.

STK502 User Guide

6-1

Rev. 2528A–AVR–11/02

Page 26 Page 28
Image 27
Page 26 Page 28
Contents STK502 User Guide Page Table of Contents Technical Support STK502 Top Module for STK500 Section IntroductionSupports the ATmega169 with Built-in LCD Controller FeaturesATmega169 on Section Using the STK502 Top ModuleConnecting the STK502 to the STK500 Starter Kit Placing anConnectors Are not duplicated on the STK502STK502 must be used 2.2 2.1 PG0 PG5Programming the ATmega169 In-SystemProgramming High-voltage Parallel Programming High-voltageJtag Connector Configuration STK502-PCB or in Complete SchematicsLCD Display On the Display 11.Pin out for LCD Headers12.Jumper to connect COL1 to COL2 AVR Sensor ATmega169 1.2 PF10 SwitchTroubleshooting Guide Section Troubleshooting GuideTroubleshooting Guide LCD-display Section Technical SpecificationsSystem Unit Operating ConditionsLayout for the STK502 LCD-display Number Four STK502 LCD Bit MappingsNumber Two Number ThreeBit Mappings for LCD Alphanumeric Digit Number Seven Number SixBit Mappings for LCD Alphanumeric Digit Number Six Number SevenSection Technical Support Technical Support Section Complete Schematics Schematics, 1 Schematics FigureSchematics Assembly Drawing, 1 Complete Schematics Atmel Headquarters
Top Page Image Contents