NetStreams Musica Power Amplifier
Configuration for Stereo Operation
Input Connections
Run a Cat5e cable from the Keypads Audio Port (EIM) output, to the input of the MU290.
Output Connections
RJ45 Output
The RJ45 Terminator Plug comes installed in the MU290 but can be removed to add additional MU290’s or an Audio Port. If an Audio Port is not used then the RJ45 Terminator plug will need to be installed in the last MU290 of the chain. See figure 1.
Speaker Output
Speaker leads connect via a 4 position Phoenix connector. Be sure to match up the polarity of correctly. (See amp for polarity).
Prepare speaker leads by stripping insulation back 3/16” (6mm). Twist strands together slightly to ensure that there are no stray strands. Connect to terminals that correspond to the channel outputs as follows:
Fig. 1
With a small,
Check the position of the
The amplifier is now ready for stereo operation.
All specifications subject to change without notification. All rights reserved. Copyright©2004 NetStreams
main.512.977.9393 / fax.512.977.9398 / 3600 W. Parmer Lane, Austin, TX 78727 / www.netstreams.com
5 |