17
Selects initial mode of a GPS receiver if your CPU is fitted with the internal Trimble GPS unit. Factory setting is OFF.
GPS mode
This parameter is pertinent if your CPU is fitted with the internal Trimble GPS device. It selects the standard protocol used by GPS receiver to transmit data. The NMEA and TSIP/TAIP options are available. Factory setting is TSIP/TAIP for F5207A and NMEA for F5217A.
Radio ring indicator (RI)
Enables or disables
System ring indicator (RI) mask
Masks Ring Indicator from any serial port. When masking is disabled, RI from any serial port will wake up the device. Factory setting is DISABLE.
Note: for serial COM3 port, see also Radio ring indicator (RI) parameter.
iDEN programming mode
This parameter is pertinent if the device is fitted with an internal iDEN modem. It turns on or off a special programming mode of the iDEN modem. Factory setting is OFF.
SB9600 mode
This parameter is pertinent if the device is fitted with an internal iDEN modem and allows a data in SB9600 format to be encapsulated. Factory setting is ON.
Heater optimization
The CPU has internal hard disk heater, which allows operating in low temperatures. This parameter optimizes automatic heating, based on the ambient temperature in your area. Factory setting is 0°F.
Hard disk heating when device is off
An internal automatic hard drive heater allows the CPU to operate properly in low temperatures. When the device is turned off, an automatic heater will maintain the hard drive temperature within the operating range for a certain period of time set by this parameter. The period range is 0 to 16 hours. Factory setting is 16 hours.
CPU serial number
This
Refer to Appendix H for factory setting of the CPU configuration parameters.