Ericsson W2x Series manual USB Interface, Ethernet Interface, Telephony Interface W25, Connectors

Page 14

2.4

USB Interface

 

The W2x terminals include a USB 2.0 Host Controller with two (2) ports

 

(type A) supporting both full speed and high-speed. The USB interface

 

supports one low power device per port hence the maximum power

 

consumption of a device is 100 mA.

 

Maximum practical cable length for USB is 5 m.

2.5

Ethernet Interface

 

The W2x terminals include an Ethernet switch with four (4) external LAN

 

4x10/100BaseTx ports (female RJ45) for connection to PC equipment.

 

Each Ethernet port supports rate auto-negotiation and MDI/MDIX auto-

 

detection.

 

The MDI/MDIX auto detection allows the user to plug in either a straight or

 

crossed Ethernet cable regardless of how the other end is connected.

 

Maximum cable length for Ethernet is 100 m.

2.5.1

Built-in LED indicators

 

Each Ethernet connector has two built-in indicators. The left indicator

 

shows the speed of data traffic between the W2x terminals and the

 

connected client. If the speed is 100 Mbps, the indicator is green. When the

 

indicator is unlit, the speed is 10 Mbps.

 

The indicator to the right is green when a LAN connection is established

 

and flashes to show data traffic activity.

2.6 Telephony Interface (W25)

The Ericsson W25 includes dual POTS interface (FxS). The port marked “Phone” is the primary port to be used for making phone calls. The other port (marked “Phone/Fax”) is intended for fax machines and complementary telephony services.

The ports are intended for on premises phones and should typically be connected to devices within one building. Short loops (max 500Ω) is supported.

The maximum ringing load for each port is 3 REN (corresponding to three

(3)old fashioned phones with mechanical bells or twenty (20) modern phones with electronic ringing).

Characteristic impedance, gain, current etc of the ports are controlled by software. DTMF dialing are supported. The ports have protection to prevent the unit to be damaged by ESD (Electro Static Discharge).

2.7 Connectors

The bottom of the W2x terminals includes the connectors as described below.

2.7.1W20/W21 Connectors

The Ericsson W20/W21 is equipped with the following connectors located at the bottom of the unit:

14

221 02-FGB 101 327 Uen C - December 2006

Image 14
Contents W2x Series Contents FAX Support W25 only Acronyms and Abbreviations Introduction Ericsson W20/W21 Data TerminalTwo USB 2.0 ports File and printer sharing Ericsson W2x Feature SummaryEricsson W25 Data and Voice Terminal Analogue voice services W25 only SW auto update Remote Management Capability Via SSHBattery Backup W25 only Power SupplyPower Adapter W2x terminals can be powered fromHsdpa Throughput Rates Category Peak data rate No of codes ModulationData Transmission Band Frequencies MHz W20e Conducted Transmit Power dBmFrequency Bands W20 W20aUMTS/GSM Window Antenna Frequency Bands W21/W25Standard UMTS/GSM Antenna UMTS/GSM Roof AntennaInternal Wlan Antennas Wireless LAN Wlan InterfaceWireless Radio Channels Channel Geographic Indoor Usage Number FrequencyEthernet Interface ConnectorsUSB Interface Telephony Interface W25Text Type Function LED Indicators2 W25 Connectors Text Color Function 1 W20/W21 LED Indicators2 W25 LED Indicators Layer 2 Functions Data Features and FunctionInternet Protocol Services USB Services Authentication Line Interface Telephony Features W25 onlyUMTS/GSM Supplementary Services Dial Process Dtmf Transmission Emergency CallsSecurity SignalingFax Support W25 only Media StreamSSIDs Wireless LAN WlanWireless Security Access Control Configuration and ManagementCommand Line Interface Web User InterfaceManagement Tools Software UpdateFault Management System LogWAN interface Security ManagementTems Investigation Support LAN interfacePIN Lock SecurityOperator Lock Mechanical Anti-Theft KitWeee Marking Regulatory ApprovalsRoHS Directive EnvironmentalEgsm Enhanced GSM IPv4VoIP QoSUPnP Ericsson Enterprise AB 2006 All Rights Reserved 221 02-FGB 101 327 Uen C December

W2x Series specifications

The Ericsson W2x Series is a robust line of advanced wireless communication solutions designed to meet the growing demands of both urban and rural environments. With a primary focus on enhancing mobile broadband experiences, the W2x Series represents a significant leap in technological capabilities, featuring both hardware and software innovations that drive connectivity forward.

One of the core features of the W2x Series is its support for next-generation mobile standards, including 5G New Radio (NR). This enables operators to deliver higher data speeds, reduced latency, and increased capacity to end-users. Leveraging Massive MIMO technology, the W2x Series utilizes multiple antennas at the base station, allowing for simultaneous connections and more efficient spectrum usage. This results in improved coverage and enhanced overall network performance.

The W2x Series also integrates advanced beamforming techniques. These techniques focus the signal in specific directions, which not only improves signal strength but also minimizes interference. This capability is particularly beneficial in dense urban environments where signal degradation can be a challenge.

In addition to its impressive 5G capabilities, the W2x Series is designed for seamless integration with existing 4G networks, ensuring operators can provide a smooth transition for users without significant disruption. This backward compatibility is crucial as it allows for a gradual rollout of new services while maintaining support for legacy devices.

Power efficiency has been a key consideration in the design of the W2x Series. The advanced hardware is engineered to consume less energy, thereby reducing operational costs and contributing to sustainability goals. Additionally, the series supports Intelligent Energy Management features that optimize power consumption based on real-time usage patterns.

Another distinguishing characteristic of the W2x Series is its modular architecture. This flexibility allows network operators to customize their deployments according to specific regional needs and operational requirements. Whether installed in remote locations or urban centers, the W2x Series can adapt to various physical and environmental constraints.

Security is also paramount in today's connected world. The W2x Series incorporates robust security frameworks that safeguard user data and ensure compliance with international standards. This focus on security fosters trust among users as well as network operators.

In summary, the Ericsson W2x Series stands out with its cutting-edge features, including 5G NR support, Massive MIMO, beamforming technology, and modular design. Combined with energy efficiency and enhanced security, this series is well-equipped to support future wireless demands, making it a vital asset for network operators looking to enhance service offerings and user experiences.