Aiwa CSD-TD20 manual Power Supply, Specifications

Power Supply

6STANDBY OPE/BATT

The 6STANDBY OPE/BATT indicator lights up while electric current flows to the unit.

Using on AC House Current

Connect the AC cord as illustrated below.

	to the AC inlet of the unit
supplied AC cord	to an AC outlet
	(AC 230 V, 50 Hz)

Specifications

Tuner section

Frequency range, antenna — FM: 87.5 - 108.0 MHz Rod antenna,

MW: 531/530 - 1,602/1,710 kHz (9/10 kHz step) Ferrite bar antenna,

LW: 153 - 288 kHz Ferrite bar antenna

Deck section

Track format — 4 tracks, 2 channels / Frequency range — Normal tape: 50 - 12,500 Hz (EIAJ) / Recording system — AC bias / Erasing system — Magnet erase / Heads — Recording/playback head (1), Erasure head (1)

CD player section

Disc — Compact disc / Scanning method — Non-contact optical scanner (semiconductor laser)

General

Speaker — 100 mm cone type (2) / Output — Headphones jack (stereo mini-jack) / Power output — 2.5 W + 2.5 W (EIAJ 7 ohms, T.H.D. 10%),

1.9W + 1.9 W (DIN 1% Rated Power) / Power requirements — DC 12 V using eight size C (R14) batteries, AC 230 V, 50 Hz / Power

consumption — 16 W

Dimensions (W × H × D) — 435 × 184 × 277 mm Weight (excluding batteries) — 3.7 kg Accessory — AC cord (1)

•Specifications and external appearance are subject to change without notice.

•Specifications, trade mark, model name and the double square symbol

are marked on the bottom of the unit.

COPYRIGHT

Please check the copyright laws relating to recordings from disc, radio or external tape for the country in which the machine is being used.

CAUTION

Use only the supplied AC cord. Use with other cords may result in the risk of fire.

Using on Batteries

Open the lid of the battery compartment on the rear and insert eight R14 (size C) batteries, not supplied, with the 0 and 9marks correctly aligned. Then close the lid.

To switch from AC power supply to battery power supply, disconnect the AC cord from the AC inlet.

R14 (C)

When to replace the batteries

The 6STANDBY OPE/BATT indicator becomes dim, the tape speed slows down, volume decreases, or sound is distorted during operation.

Notes on batteries

•Do not mix different types of batteries or old batteries with new ones.

•When the unit is not to be used for a long period, remove the batteries to prevent needless battery wear.

•Never recharge the batteries, apply heat to them or take them apart.

•Remove dead batteries.

If liquid leaks from the batteries, wipe thoroughly to remove.

Unless otherwise noted, the illustration in the Operating Instructions shows the CSD-TD21.

Maintenance

To clean the cabinet

Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.

To clean the heads

When the tape heads are dirty;

-high frequency sound is not emitted

-the sound is not adequately high

-the sound is off-balance

-the tape cannot be erased

-the tape cannot be recorded on

After every 10 hours of use, clean the tape heads with a head cleaning cassette.

Use separately sold dry-type or wet-type cleaning cassette.

Refer to the instructions of the cleaning cassette for details.

Lens

To clean the lens

Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge.

ENGLISH 3