Cisco Systems DPC3008CC manual Management, Front panel, Back panel

Page 11

Linksys DPC3008/EPC3008

Management

•• Software upgradeable by network download

•• Remote manageability using SNMP V1/V2 and V3

Front panel

The front panel of your modem provides LED status indicators that indicate how well and at what state your modem is operating.. See “Understanding the Front Panel Indicators” on page 14 for more information..

1.POWER—ON, power is applied to the modem..

2.DS—ON, the modem is receiving data from the cable network..

3.US—ON, the modem is sending data to the cable network..

4.ONLINE—ON, the modem is registered on the network and fully operational..

5.LINK—ON, the Ethernet connection is operational.. BLINKING indicates that data is being transferred over the Ethernet connection.. OFF indicates that the Ethernet connection is not connected or has been disabled by the user..

Note

After the modem is successfully registered on the network, the POWER, DS, US, and ONLINE LEDs stay on continuously to indicate that the modem is active and fully operational..

Product Overview

Back panel

DPC3008

EPC3008

1.ON/OFF SWITCH (Provided only on products that carry the CE mark)— Allows you to turn off of the modem without removing the power cord.. Turning the modem off using this switch makes sure that the modem is consuming no energy..

2.POWER—Connects the modem to the provided AC power adapter.. Use only the power supply provided with your modem..

3.ETHERNET—One RJ-45 Ethernet port connects to the Ethernet port on your computer or network..

4.RESET—Press and hold this switch for 2 seconds to restore settings to factory defaults and reboot the modem..

Caution

The RESET button is for maintenance purposes only.. Do not use unless instructed to do so by your service provider.. Doing so may cause you to lose any settings you have selected..

5.MAC ADDRESS LABEL—Displays the MAC address of the modem..

6.CABLE—F-connector connects to an active cable signal from your service provider..

9

Page 10 Page 12
Image 11
Page 10 Page 12
Contents User Guide Contents About this guide Important Safety InstructionsWhere to find more help Software and firmware use Aviso a los instaladores de sistemas Catv Mitteilung für CATV-TechnikerOutdoor grounding system Important safety instructionsPower source warning Ground the productProvide ventilation and select a location Verify the power source from the On/Off power lightProtect the product from lightning Eliminate AC mains overloadsRegulatory compliance statements CE compliance FCC Declaration of ConformityCanada EMI regulation RF exposure statementsImportant Safety Instructions Introduction Package contentsFeatures Product OverviewBack panel ManagementFront panel Positioning your modem Installing Your ModemRequirements Positioning the modem Wall-mounting the modem optionalSelecting a wall mount location Equipment neededMounting the modem to the wall Installing the modemDimensions Connect devices to the modemInstalling Your Modem Normal operations AC power applied Understanding the Front Panel IndicatorsIndicator charts Normal operations power upHow do I configure TCP/IP protocol? FAQs and TroubleshootingFrequently asked questions How do I renew the IP address on my computer? To configure TCP/IP on Macintosh systemsCommon troubleshooting issues Check and correct Tips for improved performanceModem does not register an Ethernet connection Modem does not register a cable connection3425-01585
Top Page Image Contents